The GM32 in-situ gas analyzer measures SO2, NO, NO2 and NH3, pressure and temperature in the gas duct. Direct, fast and without gas sampling and transport. Due to self-monitoring, the measured values are reliable. In case of a malfunction, an early warning will be shown. For emission measurement of SO2 and NO, the GM32 is tested for suitability according to European standard EN 15267. An Ex-type with extensive safety functions and sophisticated system technology is also available.
For monitoring and control in flue gas purification, such as denitrification plants, desulfurization plants and converters
Emissions monitoring according to EU directives or local regulations
Device properties:
No gas sampling, no gas transport, no gas conditioning
Up to four measurands at the same time, plus process temperature and pressures
Numerous independent measuring ranges with consistent accuracy
Automated self-test function (QAL3) without test gases
Overpressure encapsulated type Ex-zone 2
Benefits
Nearly uncompromised measured values measured directly in the gas duct
Short-term process deviations can be measured
Representative measurement by selection of cross-duct or measuring probe type
Fast on-site service possible due to modular design
Long maintenance-free intervals
Cost-effective in-situ gas analyzer — Ex-type also available
Low cost of installation and operation, no test gases required
Discover how Ciments Calcia is transforming its French sites with low‑carbon innovation, next‑gen clinker production, and high‑performance gas analysis systems delivered with speed and reliability.
Learn how Raman Spectroscopy can provide analysis solutions for challenging stream conditions, by reading the white paper focused on two different customer case studies.
Borealis is monitoring of polypropylene and polyethylene grades during olefin polymerization reactions in continuously fed loop reactors in the Chemical Industry.
–20 °C ... +55 °C Temperature change maximum ±10 °C/h
Ambient humidity
≤ 95 % Relative humidity; non-condensing
Degree of protection
Standard: IP 65, IP 69K Ex-version: IP 65
Conformities
Approved for plants requiring approval 2001/80/EC (13. BImSchV) 2000/76/EC (17. BImSchV) 27. BImSchV TA-Luft (Prevention of Air Pollution) EN 15267 EN 14181 MCERTS GOST
Product safety
CE
Hazardous area approvals
IECEx: Ex pzc op is [ia] IIC T3 Gc ATEX: II 3G Ex pzc op is [ia] IIC T3 Gc
The GMK03 gas test unit is used to test the linearity of the
measurement results of gas analyzers as required for a
metrological quality test (e.g. for QAL2, QAL3). For this purpose,
the GMK03 gas test unit can simulate several graded test gas
concentrations with a single (suitable) test gas.
The GMK03 gas test unit is used to test the linearity of the measurement results of gas analyzers as required for a metrological quality test (e.g. for QAL2, QAL3). For this purpose, the GMK03 gas test unit can simulate several graded test gas concentrations with a single (suitable) test gas.
The repair service ensures that the functionality of the GM32 emission monitoring solution is restored quickly. The device is also given a general overhaul in order to prevent future failures.
